SAVE

Syntax:

save "filename", <byte or int device_no>, <int start_address>, <int end_address>

The SAVE command saves the given memory area into a file on the given device by calling the KERNAL SAVE routine. The first two bytes in the file will contain the start address.

Note: The last byte written in the file will be end_address - 1.

Tip: Prepend the file name with @0 to overwrite an existing file on disk. Example:

save "@0:existingfile", 8, 49152, 49408

Use the FERR() function to get error information on the saving process.

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies

Discussion

Enter your comment. Wiki syntax is allowed: